The get Command

The get command is dip's way of setting a variable. The simplest form is to set a variable to a constant, as used throughout the above example. You may, however, also prompt the user for input by specifying the keyword ask instead of a value:

           DIP> get $local ask
           Enter the value for $local:

A third method is to try to obtain the value from the remote host. Bizarre as it seems first, this is very useful in some cases: Some SLIP servers will not allow you to use your own IP-address on the SLIP link, but will rather assign you one from a pool of addresses whenever you dial in, printing some message that informs you about the address you have been assigned. If the message looks something like this ``Your address: 193.174.7.202'', then the following piece of dip code would let you pick up the address:

	wait address: 10
	get $locip remote